The Universal Hardware Pull Plate is the perfect complement to the Rim Exit Device (UH40010). This pull plate adds a clean and contemporary look for the opposing side of the door. It's comes pre-drilled with a 1-1/4" hole for use with the exit device rim cylinder which makes it ideal for any storeroom. The pull plate is made from corrosion resistant zinc diecast and has a sleek satin chrome finish that's built to withstand heavy use indoors or outdoors. Universal Hardware is the pro's choice for commercial door hardware and flat goods.
- Features - The perfect complement to the UH40010 Rim Exit Device to allow Installation with a 161 door prep. It has corrosion resistant stainless steel for durability and long-lasting use.
- Measurements - Handle is 5 1/2” center to center.
- Additional Features - Pre-cut slot for deadbolt cylinder, through-bolt design for durability, and night latch function.
- Installation - All fasteners are included, along with a cylinder sleeve to facilitate Installation with 161 door prep (2-1/8" bore).
- Universal Hardware is the pro's choice for commercial door hardware and flat goods.
If the through bolts do not line up with the exit device send new UH40011 with drill template seen here.
The 1-1/8” holes are positioned such that a file could probably be used to notch enough material out to make room for the center thru posts of the new 40011.
The new 40011 plate will cover the 1-1/8” holes on one side and the mounting plate of the 40010 exit device will cover the holes on the push side. (Small or large head cover will both do the job.)